“ n” in the command represents the number of times that you want to write zeros in every sector. Simply, alter the drive letter with the drive letter of the drive you are trying to format. In the terminal, paste this command and hit Enter.įormat drive letter: /FS:Filesystem /p: n Open the Command Prompt with the administrative rights.Ģ. To completely format a drive you have to low-level format it.ġ. This way you can format the drive in any choice of the format you prefer the most.Īll the formatting processes discussed so far don’t permanently remove all the data from the drive. If the drive letter of the drive is “F:”, the commands will be –įormatting the disk F: in the NTFS file system – format F: /fs: NTFSįormatting the disk F: in the FAT32 file system format F: /fs: fat32įormatting the disk F: in the exFAT file system – format F: /fs: exFAT Now, the File System in the command represents the specific format in which you want to format the drive. Replace the ‘drive letter:’ with the ” drive letter of the drive. Paste this command, modify it according to your requirement, and hit Enter. You can use the specific commands to format the drive in specific formats.ī. The drive will be formatted way faster than before. [Just replace the drive letter with the particular drive letter of the drive.įor the ‘F:’ drive, the code will be – format F:/q Open the Command Prompt with the administrative rights.ī. The usual formatting of the drive takes a long amount of time. This way you can easily format the drive.Īdditional Options of formatting USING CMD – You can easily alter it later from File Explorer.įinally, press the ‘ Y‘ key and hit Enter to complete the format. We have used ‘New Volume’ as the volume label. When you are asked to ‘Enter the current volume label’, type the volume name. [ NOTE – Just the same step as before, replace the ‘drive letter:’ with the particular drive letter of the drive.Īs the drive letter is the ‘F:’ letter. Then, execute these codes to format the drive.
0 kommentar(er)
